Operation Manual

Burley d’Lite Owner’s Instruction and Safety Manual

FRONT REFLECTORS:

1. Locate one of the front

tongue mounts (A). Locate

the screw hole (B) and the

locating boss (C) on the front

tongue mount. Each reﬂ ec-

tor has a screw hole (D) and a

location stub (E).

2. Position the back face of

the reﬂ ector onto the front

of the tongue mount. Line

up the tongue mount screw

hole (B) with the reﬂ ector

screw hole (D) and the reﬂ ec-

tor stub (E) with the tongue

mount locating boss (C).

3. Insert the mounting screw thought the screw hole (B) in the rear of the tongue

mount and then into the reﬂ ector screw hole (D). Tighten the screw until it is

snug. Do not overtighten.

4. Repeat for the other side of the trailer.

III. Installing the Quick-Release Levers

In the bag with the reﬂ ectors you’ll ﬁ nd two quick-re lease levers. Install these

through the hollow axle of the wheel. Make sure the lever is on the ﬂ at side of the

wheel, the thumb nut is on the deep-dished side, and the springs are mounted

on each side as shown in the illustration below.

The quick-release

lever must be on

flat side of wheel

and thumb nut on

deep-dished side.

This ensures that the

lever will be on the

outside when wheel

is properly installed.

Deep Dish

Quick Release Lever

Thumb Nut

Flat