B2 Bomber User Guide / Owners Manual
14
1. Set B2 to EXT
2. Open Dante Controller, select DEVICE INFO
3. Double Click on device “B2-xxxxxx”
4. Click on CLOCK STATUS. (Fig. 13, below)
5. Set B2 Bomber to “Preferred Master”, select “Enable to sync to External”
6. Make sure each device including host DAW is set to correct sample rate in
Device Cong (as per step 8, page 9)
Fig. 13: Example shows B2 ADC on External clock. Dante card is also synced to External clock.
SEE FIGURE 14 (NEXT PAGE) FOR B2 EXTERNAL WORD CLOCK CLOCKING DIAGRAM
CLOCKING B2 BOMBER ADC/DAC TO EXTERNAL WORD CLOCK: