B2 Bomber User Guide / Owners Manual
11
8. Click on DEVICE CONFIG. then select sample rate and select lowest latency (With the Dante
PCIe Card, latency of 150 usec is possible. With the Virtual Sound Card, latency is 4msec).
(Figure 10, below).
Note: you will have to set sample rate for each device!
Figure 10: Example shows Device Cong for rst ADC.
Note: With multiple units, sample rate needs to be set for each unit, including the DAW.
Note: Actual latency used between two endpoints is the larger of the two endpoint settings. In this case,
anything to or from Dante Virtual Soundcard can only go as low as the setting for DVS (4ms being the
lowest). Using a PCIe card is recommended to get down to 150µs.