User guide

35
Packaging, transport, storage
To run X.TUNE, the positioner must be in the AUTOMATIC
operating status
(DIP switch 4 = OFF).
→ Start X.TUNE by pressing button 1 for 5 sec
9)
.
While X.TUNE is running, LED 1 flashes very quickly (green).
When the automatic adjustment has completed, LED 1 flashes slowly
(green)
10)
.
The changes are automatically transferred to the memory (EEPROM)
only when the X.TUNE function is successful.
If LED 3 (red) is lit after the X.TUNE function started, the
X.TUNE function was ended due to a fault.
• Check possible faults
(see “Tab. 7: Error messages while the X.TUNE function
is running” ).
• Then repeat the X.TUNE function.
9) The X.TUNE can also be started via communications software.
10) If a fault occurs, LED 3 is lit red.
12. PACKAGING, TRANSPORT,
STORAGE
NOTE!
Transport damages!
Inadequately protected equipment may be damaged during
transport.
• During transportation protect the device against moisture and
dirt in shock-resistant packaging.
• Follow the allowable storage temperature.
Incorrect storage may damage the device.
• Store the device in a dry and dust-free location!
• Storage temperature. -20 – +65 °C.
Damage to the environment caused by device components
contaminated with media.
• Dispose of the device and packaging in an environmentally friendly
manner.
• Observe applicable regulations on disposal and the environment.
english
Type 8791