Owner's manual

71
8. REPLACING A TERMINAL OR PNEUMATIC
MODULE
For installation of the terminal-pneumatic module subassembly, the modules are aligned to each other during pro-
duction. The alignment ensures compliance with all tolerances on the interfaces (profile holder - plug –
fluidic ducts).
Mount the pneumatic module itself on a terminal module and, when integrating it into the system, ensure that all
interfaces (profile holder - plug – fluidic ducts) interlock without difficulty. Otherwise, proceed as follows:
→ Take the subassembly out of the system again.
→ Slacken the three screws on the back of the terminal module.
→ Re-align the pneumatic module on the terminal module.
→ Tighten the three screws again.
Instructions for conversion or expansion of the system.
Grease sealing rings!
To facilitate installation and to prevent damage, the sealing rings of the pneumatic modules should be
greased during the installation work (e.g. with Centoplex 2 from Klüber Lubrication).
S
erial numbers and identification number of the system lose their validity!
During conversion or expansion work the serial and identification numbers of the pre-assembled systems
lose their validity.
In this case we recommend removing the identification plate and affixing a suitable note to the device.
Type 8650
english
Installation