Owner's manual

66
5. CONFIGURATION, CONVERSION AND
EXPANSION OF AN EXISTING SYSTEM WITH
INDIVIDUAL SEGMENTS
5.1. System Configuration
Two inclined tie rods (3) connect the modules to each other.
→ To assemble modules, place two modules on the profile rail and push together.
→ Now screw the right module to the left one with two inclined tie rods.
(Hexagon-socket wrench 3 mm, torque 0.6 Nm)
→ Other modules can be installed on the right in the same way.
→ Finally, tighten all clamping bolts (1) by turning them clockwise (stipulated torque 1.5 Nm).
1
Clamping bolts
Fig. 8: Adding segments
Type 8650
english
Installation