User guide
English
8645 - 75
The multipole module brings a bundle of individual core pairs
together to form a multi-core cable that enables the signal to
pass from the higher-level controller to the FreeLINE automation
system.
Illustration: Multipole module
Operating voltage 24 V -15 % / +20 %
Residual ripple 2 Vss
Electrical connections M2
jack, leads for inputs
plug, leads for outputs / valves
Pneumatic connections
Compressed air supply
Exhaust air
Auxiliary control air
Pilot control exhaust air
G 1/4”, NPT 1/4”, D10
G 1/4”, NPT 1/4”, D10
M5, D6, D4, D 1/4”
M5, D6, D4, D 1/4”
Material PBT
Weight 485 g
The multipole module itself does not have any protection against SURGE pulses.
As the multipole module is controlled via the inputs and outputs of a PLC, care must be
taken that a corresponding protection device is provided further upline (e.g. at the PLC).
If the multipole module is used on conjunction with feedback inputs, we recommend the
installation of a filter (> 4 ms) in the higher-level control unit (e.g. PLC). Otherwise incorrect
messages may be transmitted when using M8 plugs (without plastic insert) due to ESD.