Owner manual
59
Installation
Alternative for large valve blocks:
Remove the predecessor module,
→
Snap the valve block onto the standard rail, →
Slide the block to its final position, →
Snap on the predecessor module again. →
Before dismounting pneumatic lines and valves, turn off the pressure and vent the lines.•
Do not insert any foreign objects into the base module (24 V supply bus)!•
The function module is a component of the electronic base module. It can be replaced in consideration of the points
listed below:
Depressurize AirLINE system.
→
Using a screwdriver, loosen the fastening screws of the valves. →
Remove valve from the valve plug. →
Flange seal and O-ring (3/2-Way valve) must not be soiled. →
Detach function module above rear catch mechanism and remove vertically without tilting it from the distributor →
module (backplane bus).
Place new function module vertically on the distributor module (backplane bus) and press down until it clicks
→
into position.
Connect valve, with the cleanly inserted flange seals / O-rings, to the valve slot and tighten the screws
→
according to the following assembly diagram (see Figure 32:Tightening the screws).
20 Ncm
20 Ncm
30 Ncm
30 Ncm
Figure 32: Tightening the screws
deutsch