Owner manual
56
Installation
Before dismounting pneumatic lines and valves, turn off the pressure and vent the lines.•
Before reaching into the device or the equipment,• switch off the power supply and secure to prevent
reactivation!
Observe applicable accident prevention and safety regulations for electrical equipment! •
(Electronic modules and valves may also be replaced while the power supply is on)
Installation may be carried out by authorized technicians only and with the appropriate tools!•
Secure system from unintentional activation.•
Following installation, ensure a controlled restart.•
If the seals are not seated correctly, leaks and malfunctions may occur due to pressure losses.
Ensure that the seals are seated correctly in the area of the electronics and pneumatics.•
The electrical connection requires exact contacting.
Do not bend contacts.•
If connections are damaged or bent, replace the affected components.•
Do not switch on the system unless the components are in perfect condition.•
To prevent damage to the system, use only direct current for the system power supply.
To prevent a pressure drop, design the system pressure supply with the largest possible volume.
deutsch