Instruction Manual

63
Start-Up
10. START-UP
10.1. Safety instructions
WARNING!
Risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the device and the area around it.
• Before start-up, ensure that the operating personnel are familiar with and completely understand the contents
of the operating instructions.
• Observe the safety instructions and intended use.
• Only adequately trained personnel may operate the equipment/the device.
10.2. Fluid start-up
NOTE!
• Switch on the supply pressure.
• Only then switch on the power supply!
Procedures before fluid start-up
→ Check connections, voltage and operating pressure!
→ Ensure that max. operating data (see type plate) are not exceeded!
→ Check that connections 1 and 3 or 5 have been configured correctly; these must not be mixed up!
→ Release manual actuation during electrical operation!
10.3. Electrical start-up
The start-up of the AirLINE system corresponds to the installation of the decentralized peripheral device
ET200S. All steps required here can be found in the Siemens handbook "Decentralized Peripheral System
ET200S", Chapter 6 Start-up and diagnosis (ET200S EWA4NEB 780602401-06).
english
Type 8644