Owner manual

12 - 8623
english
Î Move to the next position.
Î After reaching the last value, exit the programming mode:
You will return to the Standard mode.
When you leave the Programming mode, the currently-set
values will be saved, and a Reset carried out.
Attention: any current control function will be interrupted!
NOTE:
Î Hold the key down for 2 seconds.
The control unit is now in the programming mode.
Each position can be individually adjusted in the sequence of
Paragraphs 7.3.2 to 7.3.9.
Î Change the currently-adjusted value (blinks).
7.3 Programming mode
As only the control unit Type 8623-B is in the Programming
mode, the flow controller continues to work with the old values
until the Programming mode is exited.
NOTE: