Manual

6 Setup - sensors from software 4.0.0
6.1 Common adjustment menu for all signal
outputs
Through the parameter adjustment the instrument is adapted to the
application conditions. The parameter adjustment is carried out via an
adjustment menu.
Information:
In this operating instructions, all general parameters are described.
Additional instrument-specific parameters are described in the
operating instructions of the respective sensor.
The following presentations are available in the measured value
display:
l Level as digital value, sensor TAG
l Level as digital value and bar graph, sensor TAG
With [->] you select different presentations of the measured value.
From each of these presentations, you can reach with [OK] the menu
overview. With [ESC] you move from the menu overview again to the
measured value indication.
The main menu is divided into five sections with the following
functions:
Setup: Contains measurement loop name, settings to the medium,
application, vessel, adjustment, damping, signal output
Display: Contains language changeover, settings to the indicated
measured value as well as for lighting
Diagnosis: Contains information to the device status, peak value,
electronics temperature, reliability, simulation and echo curve
Additional settings: Contains measuring units of the instrument, fault
signal suppression, linearization curve, sensor length, PIN, date/time,
reset, HART mode/Profibus PA settings, copy function for sensor data
Info: Shows instrument name, instrument version, calibration date,
sensor features
Measu
red value indica-
tion
Main
menu
22 Indicating and adjustment module
6 Setup - sensors from software 4.0.0
41787-EN-120316