Manual

3
1. ABOUT THIS MANUAL ................................................................................ 5
1.1. Symbols used ......................................................................................5
1.2. Definition of the word "device" ...................................................5
2. INTENDED USE ...............................................................................................6
2.1. Restraints ............................................................................................... 6
2.2. Ex certification .....................................................................................6
3. BASIC SAFETY INFORMATION .............................................................. 7
4. GENERAL INFORMATION .......................................................................... 8
4.1. Manufacturer's address and international contacts ........ 8
4.2. Warranty conditions ..........................................................................8
4.3. Information on the Internet ...........................................................8
5. DESCRIPTION ..................................................................................................9
5.1. Area of application ............................................................................ 9
5.2. General description .......................................................................... 9
5.2.1. Construction ...........................................................................9
5.2.2. Principle of operation ...........................................................9
5.3. Description of the name plate on the standard 1062 .... 9
5.4. Description of the name plates on the 1062 ATEX ...... 10
5.5. Versions available ........................................................................... 11
6. TECHNICAL DATA ....................................................................................... 11
6.1. Conditions of use ............................................................................ 11
6.2. Conformity of the 1062 ATEX to standards
and directives .................................................................................... 11
6.3. Conformity of the 1062 approved by CSA ......................... 12
6.4. General technical data ................................................................. 12
6.4.1. Mechanical data .................................................................12
6.4.2. General data ........................................................................13
6.4.3. General data specific to the devices approved by
CSA .......................................................................................14
6.4.4. Electrical data......................................................................14
7. ASSEMBLY ...................................................................................................... 16
7.1. Safety instructions.......................................................................... 16
7.2. Replacing the top part of an actuator size 40mm ......... 17
7.3. Fitting the position feedback to a pneumatic actuator 1 7
7.4. Fitting the position feedback with stroke
limiter to a pneumatic actuator size 50 to 80mm ......... 19
7.5. Fitting the position feedback with stroke
limiter to a pneumatic actuator size 100 or 125mm .... 23
Type 1062
Table of Contents
english