Specifications

FFoonntt//FFoonntt CCoolloorr..
Determines the font and font color used to show the meter values.
SSppaacciinngg..
This sets how far from the meter the intermediate values will be shown.
SShhooww llaarrggee//ssmmaallll ttiicckkss..
If you want tick marks along the side of the thermometer, check the box.
LLaarrggee ttiicckkss..
Enter how many large and how many small ticks you want to divide the meter.
LLeennggtthh..
This sets the size (in pixels) of the large ticks.
TTiicckk ccoolloorr..
Pick a color for the ticks.
Charts
To integrate a chart in your custom views, all you need to do is click and drag the chart component into the
Custom View Editor, click on the Chart tab in the properties window, and specify the file name of the chart you
will use. If the chart is not already set up, you will need to create the chart (see page 69) before you can use it
in the Custom View.
STATUS COMPONENTS
There are four ways to show status data: LED (round or rectangular); Status Label ; Status Picture ; and Command
and LED
. Every status component has a Status Data tab, where you specify what information is conveyed by the
component. You can use status components to show:
• The condition of a status channel or command state
• Whether a macro is running
• If a meter limit has been exceeded
• If an alarm is active
• If a status or metering channel is currently muted
• If the site is currently connected using the primary or backup method
• If the unit has been placed in local mode
• If there are captures stored on the unit that have not been downloaded to a computer
Other properties tabs depend on the type of status component you are using.
LED (Round, Rectangular, Diamond, Arrow)
The LED status components show a simple on/off indication of the condition you specify. Click on the LED
(Round), LED (Rectangular), LED (Diamond) or LED (Arrow)
tab to adjust the appearance of the LED.
BBeevveell ssttyyllee..
Adds dimension to the LED by giving it a raised or lowered appearance.
SShhooww rreefflleeccttiioonn..
Hides or shows the “reflection” on the LED.
OOnn ccoolloorr..
Specifies the color of the LED when the condition you specify is true (i.e. the status channel is in the
HIGH state, the command channel is active, the alarm condition is present, etc.).
AAuuttoommaattiiccaallllyy ddeetteerrmmiinnee ooffff ccoolloorr..
The LED will appear dark without separately defining an off color.
OOffff ccoolloorr..
Specifies the color of the LED when the condition you specify is false.
CHAPTER 8: CUSTOM VIEW EDITOR
79
CUSTOMER SUPPORT: 978-486-3711 • [e-mail] • www.burk.com