Specifications

Channels

Up to ten channels may be included in any graph. The more channels

you use, the “busier” the chart will be. Keep in mind that the channels

will share the same Y-axis.

Configure each channel separately by clicking on a channel tab on the

left side of the Channels page. Start with the tab marked 1 and

continue in order until you have entered all the channels you want to

appear on this chart.

AAuuttoommaattiiccaallllyy SSeett tthhee LLaabbeell..

Check the Automatically Set Label box to

use the channel label set up during unit configuration.

LLaabbeell..

If you want the channel label to be different from the label set up

during unit configuration, enter that label here.

SSiittee//UUnniitt..

Choose the site and unit where the desired channel is located.

CChhaannnneell..

Select the desired channel.

LLiinnee CCoolloorr..

Using automatic line color selection will assign unique colors to each channel you insert into the

graph. You can also set your own by choosing from the drop-down list.

LLiinnee SSttyyllee..

Select the desired line style from the drop-down list. This is the chart line representing the actual

channel reading.

LLiinnee WWiiddtthh..

This sets the line width (in pixels) for this channel’s line.

Editing Chart Settings

Editing your chart settings is very similar to setting them up for the first time. From the View List, click the Charts

separator, and right-click the chart you want to edit. Click Edit Chart, and then change the desired chart settings

using the Chart Properties window.

Saving Your Chart

When you are done creating or editing your chart, click OK in th e Chart Properties window. The chart will

update to reflect your new settings. Click the Save icon in the Lynx Chart toolbar to save your chart.

GSC3000 & VRC2500 INSTALLATION & OPERATION MANUAL

CHAPTER 7: SITE DATA & REPORTS