Specifications

Command Relay Unit

Wiring Interface Unit

COMPUTER REQUIREMENTS

Before installing the Lynx 5 software, verify that your computer meets the following

mmiinniimmuumm ssyysstteemm rreeqquuiirreemmeennttss

• Microsoft Windows

2000 Professional or XP (Home or Professional)

• 400 MHz processor

• 128MB RAM

• 100MB free hard drive space

• Available COM port for direct connection

• Modem for dial-up access (see page 49 for supported modems)

• Network Interface Card or dial-up networking for LAN/WAN (TCP/IP connectivity)

• Speakers for audible alarms

Note: Large or complex operations may require greater computer resources.

Lynx 5 requires firmware version 4 or later for your I/O and Voice Interface units. Factory new units shipping with

Lynx 5 already contain the latest firmware and are ready to use immediately. If you are upgrading to Lynx 5 from

a 1.x-3.x version software, first install Lynx, and then see Appendix A for instructions on uploading the new

firmware.

GSC3000 & VRC2500 INSTALLATION & OPERATION MANUAL

CHAPTER 1: INTRODUCTION