User Manual
Table Of Contents
- Using This Manual
- Table of Contents
- Introduction
- Getting Started
- Arcadia Web INterface
- Logging On
- Viewing Sites
- Adding Tabs
- Adding Sites Within Tabs
- Viewing Alarms
- Creating a Matrix
- Add a Strip Chart Tile
- Add an Angular Meter Tile
- Add a Status Label Tile
- Add a Command Button Tile
- Add an LED Button Tile
- Add a Default Site Tile
- Add an Image Tile
- Add a Label Tile
- Add a Macro Tile
- Add a Meter Status Command Row Tile
- Add a Full Row Header Tile
- Add a Text Meter Tile
- Add a M/S/C Tile
- Add a Timer Tile
- Add a Clear Alarms Tile
- Add an iFrame Tile
- Add a URL Tile
- Add a Label Full Width Tile
- Editing a Matrix
- Global Tabs
- Appendix A: TROUBLESHOOTING
19
A row of available commands is displayed at the top of the Matrix editor. The Set Width/Height command is
always visible and is used to specify a fixed size for the Matrix View. If no values are entered, the tiles in the Matrix
View will be displayed from left to right across the screen to the full width of the browser’s viewing area.
Additional rows will be added until all the tiles in the Matrix have been displayed. In the example shown in Figure
19 below, the Max Width value has been set to 12. The angular meters in the first row of Figure 19 each have a
width of 4 units, so the row wraps after three of these tiles have been displayed.
Additional commands are available when you have at least one tile selected for editing. Tiles are selected or de-
selected for editing with a single left-click of the mouse or a tap on the touch screen. Individual tiles or groups of
tiles can be selected, with subsequent clicks on a tile adding or removing it from the edit group. When you click on
a tile on the edit page it is highlighted with a red outline as shown below.
Figure 19: Modifying a Matrix
Edit Tile / Multi-Edit
Edit tile properties of all selected tiles
Delete Tile
Delete all selected tiles
Clear Selection
Clear the current tile selection
Set Width/Height
Set the fixed width and height of the Matrix View
Cut
Cut all selected tiles
Copy
Copy all selected tiles
Tiles in the Matrix editor have buffer zones between them shown as thin orange boxes. When one of these buffer
zones is selected, a context menu is displayed to add or paste tiles at that location in the Matrix.