User Manual
Table Of Contents
- Using This Manual
- Table of Contents
- Introduction
- Getting Started
- Arcadia Web INterface
- Logging On
- Viewing Sites
- Adding Tabs
- Adding Sites Within Tabs
- Viewing Alarms
- Creating a Matrix
- Add a Strip Chart Tile
- Add an Angular Meter Tile
- Add a Status Label Tile
- Add a Command Button Tile
- Add an LED Button Tile
- Add a Default Site Tile
- Add an Image Tile
- Add a Label Tile
- Add a Macro Tile
- Add a Meter Status Command Row Tile
- Add a Full Row Header Tile
- Add a Text Meter Tile
- Add a M/S/C Tile
- Add a Timer Tile
- Add a Clear Alarms Tile
- Add an iFrame Tile
- Add a URL Tile
- Add a Label Full Width Tile
- Editing a Matrix
- Global Tabs
- Appendix A: TROUBLESHOOTING
13
You can plot two channels for the strip chart.
Label
The label to use for line name
Units
Unit of measurement for the selected meter channel to chart. The units typically are kWatts,
Watts, mV, Volts, kVolts, Amps, DB, Degrees, mA, Powr, sec, Gal, Lbs, Min.
Color
The color the chart will use to draw this line
Site
The site containing this channel
Channel
Type
The meter or status channel you want to plot
Channel
Select from the list of meter or status channels
Axis
The axis (left or right) that this line will use as its Y-axis
AutoScale
Checkbox to automatically scale the Y-axis based on its values
Y-Axis Min
Y-Axis Minimum value
Y-Axis Max
Y-Axis Maximum value
ADD AN ANGULAR METER TILE
The following fields are available for creating an angular meter tile:
Tile Type
Angular Meter
Tile Size
Size of the Tile
Background color
The color of the tile background
Site
The site containing this meter channel
Channel
Select from the list of meter channels. Multiple selections are possible
Font size
Insert the size of the font that should be displayed.
ADD A STATUS LABEL TILE
The status label allows a user to determine the status of a given function. The different conditions for a status
channel that can be reported are shown below.
Status Channel
A status channel on a remote control unit
Raise Relay Active
"ON" when the specified raise relay is engaged
Lower Relay Active
"ON" when the specified lower relay is engaged
Macro Running
"ON" when the specified macro is running
Meter Below Low Critical
"ON" when the specified meter is below the second lower limit
Meter Below Low Warning
"ON" when the specified meter is below the first lower limit
Meter Above High Warning
"ON" when the specified meter is above the first upper limit
Meter Above High Critical
"ON" when the specified meter is above the second upper limit
Meter Out of Tolerance
"ON" when a meter is outside of its "normal" range (above either upper limit
or below either lower limit)
Site in Alarm
"ON" when the specified site has at least on uncleared alarm
Site Connected
"ON" when the specified site is connected to AutoPilot
Site in Maintenance Mode
"ON" when the specified site is in maintenance mode