User`s guide

Installation of Gift Cards

Table 2. Sample Panel conﬁguration details.

Name Action Panel Key Type PLU Number

Gift Card Cashout -1 (No Action) 78 40001000

Gift Card Issue -1 (No Action) 74 40001001

Gift Card Redeem -1 (No Action) 75 40001002

Gift Card Recharge -1 (No Action) 77 40001003

Gift Card Balance -1 (No Action) 76

Test the Cards!

After the conﬁguration of the Gift Cards has been completed, have the customer perform several test transac-

tions.

Perform a Terminal Update on one terminal to load the changes. Have them ISSUE a new card for $1.00. Slide

a NEW card into the slot, press 100 then the ISSUE button. A message will only appear if the transaction was

NOT successful. Take gift card from slot and tender the order with cash or credit card. Make sure a receipt prints

with the card information on it.

Next have them REDEEM part of the card. Ring up an item LESS than $1.00. Slide the gift card into the slot and

press the REDEEM button to ﬁnalize and tender the order. Remove gift card from slot. Make sure a receipt prints

with the card information on it.

Check the BALANCE of the gift card. Slide the gift card into the slot, and press the BALANCE button. A message

on screen, and a receipt should print out detailing the remaining balance on the gift card. Remove gift card from

slot.

RECHARGE the card for any additional amount. Slide the gift card into the slot, enter the amount to recharge

and press the RECHARGE button. Take gift card from slot and tender the order with cash or credit card. Make

sure a receipt prints with the card information on it.

Finally, CASHOUT the card. Slide the gift card into the slot and press the CASHOUT button. The remaining

balance of the card should be displayed in the virtual receipt. The CASHOUT amount of cash is returned to the

customer from the drawer.

IPTran Conﬁguration and Setup

Adding Gift Cards to a pre-existing IPTran system that has been installed on a previous date requires new

program parameters and/or a software reload to work. IPTrans shipped prior to June 2005 will need to be

exchanged as they are not ﬁeld upgradeable. Please contact your System Administrator or SICOM Support for

more information.