assembly Instructions

2009_09_07_ Montageanleitung_engl – HSE
Assembly Instructions
Operating and Maintenance
BURG-WÄCHTER FREESTANDING COMMERCIAL SAFES
According to VDS-Directive all commercial safes with a weight inferior to 1000 KG
must be secured with an anchorage. Please also consult your Insurance Expert
on this matter.
Important Notice:
Each commercial safe is per standard prepared for one extra anchorage. Please use only
the pre-marked position. Follow then these steps:
- In case of pre-installed anchorage at the floor or at the wall, the exterior wall has to be
bored from the inside of the commercial safe with a Ø 12 mm steal-drill at specified or
pre-marked position.
- Place the Safe in its final position.
- With a 12 mm Stone Drill bore through the pre-marked
position into the wall or the floor. Pay attention to the
existing maximum floor width and to potential heating
pipes, current conduction, etc. in the wall /floor.
- Remove the safe and bore the hole to a total depth of
14 mm. Clean the hole and then place a plug
(Fischer M10S or similar) into the hole.
ATTENTION: Depending on different types of floors and
walls special dowels are recommended to increase
possibly the effectivness of the anchoring.
ATTENTION: The gripping length of the plug must be
in solid wall or concrete. In the case of cast plaster
floor/wall then we suggest that you bore the hole in the
length of the cast plaster including the thereunder
Insulation. In this case use a longer screw with a
resistance of a min. of 10.9.
- Place the Safe in the final position and screw it tight.
- No-using anchorage-openings at the floor or at the wall of the safe have to be closed
inside with delivered closing plugs.
Important Notice: After an assault or attempted assault, after a fire as well as in the case of
inappropriate operation of construction and function, the safe loses its certification which is exposed
in the inner door side. In such a case please contact your closest Burg-Wächter Service Partner.
Maintenance:
Safety cabinets of the mentioned series do not require any regular maintenance.
In case of any failure after a longer utilisation period please contact the Burg-Wächter service partner.
The Safe loses its factory guarantee with each attempt of “self-help”. Please
never try own repair attempts without consulting a Burg-Wächter-Safe-
Engineer!
BURG-WÄCHTER FREESTANDING COMMERCIAL SAFES
Security for your valuables!