Product Manual

CareCenter MD 1.0 70-00533-02 A

3-15

Apply electrodes

Figure 3-1: Example of lead placement

To apply the electrodes from acquisition mode, with the acquisition device selected:

1. To toggle the electrode labeling (for NEHB only), select Site or Lead Wire Label.

2. To see the electrode placement scheme from another angle (side or back) click Tu r n .

3. Apply the electrodes to the patient.

• Always start with the right leg placement.

• If an electrode is not applied the electrode position on-screen blinks.

• The representation of an ECG lead starts as soon as the system recognizes the

electrodes are applied correctly.

• The electrode fault detection begins working, when you apply the right leg and

two additional leads.

4. Using the Electrode application display, try to improve the quality of the electrode

application, until all electrodes display in the adequate range.

Note: Turning on a filter does not affect the display.

To assess the skin transmission impedance, select Impedance.

The system does not display ECG during the impedance measurement.