Installation Instructions

Insert the four (4) ﬂ ange screws on these holes. From the inside of the tank, install the four (4) supplied

"O" rings on the screws then, the washers and nuts. Refer to the photo C. Tighten the nuts snugly.

IMPORTANT NOTICE :

The ﬂ ange must be set directly on the sewage tank to assure a perfect seal. Use a waterproof silicone

caulking to prevent leakage. Otherwise sewage may leak from unit, that way cause damage to property

and void warranty, due to an improper installation. When using a plywood to ﬁ nish the ﬂ oor area, install

the ﬂ ange ﬁ rst, then cut the plywood around the ﬂ ange, leaving 1/4’’ between the ﬂ ange and the plywood.

Install the pump in the "EASY FLUSH" unit, aligning the pump legs with the moulded cavities.

The rubber grommet ﬁ ts to the vent hole to assure a perfect sealing. (Photo D)

The vent pipe size is 3’’. Use an elbow to connect the pipe to the tank. The length of the pipe exceeding

the elbow has to be 2 1/2’’ to 3’’. (Photo E)

Fix the pipe to the tank by inserting the pipe into the rubber grommet. Use soap to facilitate the insertion.

Push the pipe until the elbow becomes in contact with the rubber grommet. (Photo F-G)

Cut a short piece of foam seal (3 3/4’’) as the basic wire slots seal, then glue it to ﬁ t the sloats’ shape.

(Photo H-I)

Then, cut the full length foam seal for this side of the tank. (Photo J) Glue this full length to the tank over

the previous small piece.

Using a screwdriver, make pilot holes into the foam seal to allow the bolts of the lid to reach the brass

insert. (Photo J)

STEP 6

STEP 7

STEP 8

STEP 10

STEP 9

STEP 11

STEP 12

STEP 13

"O" RINGS (4)

RUBBER

GROMMET

PHOTO C PHOTO D

PHOTO E

2 1/2’’ to 3’’

PHOTO G

PHOTO JPHOTO IPHOTO H

PHOTO F

WIRE SLOTS