INSTALLATION INSTRUCTIONS W W W. B U R C A M . C O M 2190 Boul. Dagenais West LAVAL (QUEBEC) CANADA H7L 5X9 TEL: 514.337.4415 FAX: 514.337.4029 info@burcam.com Your pump has been carefully packaged at the factory to prevent damage during shipping. However, occasional damage may occur due to rough handling. Carefully inspect your pump for damages that could cause failures. Report any damage to your carrier or your point of purchase.
SAFETY INSTRUCTIONS: This fine pump that you have just purchased is designed from the latest in material and workmanship. Before installation and operation, we recommend the following procedures: A CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO ENSURE YOU COMPLY WITH THE REGULATIONS. THESE CODES HAVE BEEN DESIGNED WITH YOUR SAFETY IN MIND. BE SURE YOU COMPLY WITH THEM.
APPLICATIONS This domestic submersible sewage pump is designed and suitable for raw sewage applications where the total head requirements do not exceed 15 feet, including pipe friction losses. CAPACITY: 5’ 4500 US GPH 10’ 3120 US GPH 15’ 720 US GPH FEATURES Vortex designed impeller made from glass filled noryl, will not corrode. Rugged cast iron pump body. Stainless steel mechanical rotary type motor seal. 2” NPT pump discharge. Thermal and overload protection.
STEP 5 Screw the pipe with the male adaptor into the 2” discharge opening in the pump. Lower pump with piping attached into the sewage basin. Make sure that the pump is as close as possible to the centre of the basin. Adjusting the pump in centre of basin will keep mechanical float switch from rubbing on side of basin. STEP 6 When you are pumping raw sewage, you must have a gas tight cover on the basin and a vent pipe from basin, connecting to home’s vent system (see diagram).
SEWAGE PUMP APPLICATION STEP 7 STEP 8 Install check valve Connect to receptacle STEP 6 STEP 10 Set gaz tight cover, discharge and vent pipes Secure cover and make vent connection STEP 5 Install discharge pipe and lower pump in centre of basin STEP 9 STEP 2 Fill with water and test operation Install sewage basin STEP 4 Drill a 1/4” hole 22 21 19 STEP 3 20 1 Cement 2” adaptor to pipe 18 2 REPAIR PARTS 17 3 13 # PART DESCRIPTION # PART DESCRIPTION 1 410036 Top handle 13 350335
TROUBLE SHOOTING GUIDE CHECKLIST NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR PRODUCT WITH THE POWER CONNECTED. DON’T JUST UNSCREW THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER FROM THE RECEPTACLE. TROUBLE PROBABLE CAUSE ACTION Motor does not run.
