Specifications

Page 8

INITIAL SETUP

CAUTION – The brewer must be disconnected from the power source throughout the initial setup, except when

speciﬁed in the instructions.

1. Insert an empty funnel into the funnel rails of the brew station.

2. Place an empty server under the funnel.

3. Connect the brewer to the power source. Water will begin ﬂowing into the tank and stop when the tank is

ﬁlled to its capacity. Display will show PLEASE WAIT...TANK FILLING until tank is ﬁlled with water.

OPERATING CONTROLS

(a) BATCH SELECTOR PADS

Pressing the pad corresponding to the recipe selects the amount of beverage to be brewed. Pressing a dif-

ferent pad after a brew cycle has been initiated does not change the brew in progress. Light indicates the

selected recipe to brew.

(b) ON/OFF PAD

Pressing the ON/OFF pad alternately turns the brewer on and off. Pressing this pad during the brew cycle

will interrupt the brew cycle, stopping the ﬂow of water. Pressing this pad during the programming of the

brewer will exit the setup and return to the main screen.

Momentarily pressing and releasing this pad begins a brew cycle.

(d) ® PAD

Pressing and holding the ® pad allows entry to the programming menus. Pressing and releasing the pad

steps through each function screen during programming.

(e) FUNCTION SCREEN

This is the display which shows the various functions of the brewer and allows the programming to be ac-

complished.

(f) FUNCTION SCREEN PADS

These are the hidden pads which are used to program the brewer.

(g) FUNNEL SENSING COIL

This is used to "receive" information from the Smart Funnel

handle (recipe name and batch size), and also

from RECIPE CARDS.

(h) SCROLL BACKWARDS

The upper left corner of the B in BUNN can be used to scroll backwards through the function list.

(i) WARMER PLATE ON/OFF PADS

Pressing these ON/OFF pads alternately turn the warmer plates on and off.

P3200-1

37467 032808