Specifications

Page 19
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SET NEW RECIPE - METHOD 2
Using a RECIPE CARD to load coffee names and
brew settings into the Single Multi-BrewWISE DBC
with Smart Funnel:
The Multi-BrewWISE DBC Grinder's memory
contains certain coffee names. If the operator uses a
coffee name that is not already stored in the grinder's
memory, a RECIPE CARD can be obtained from the
factory. The RECIPE CARD would include all the infor-
mation needed to set up that particular coffee name.
The information from the RECIPE CARD is loaded into
the grinder's memory, then into the brewer's memory
by holding the recipe card up to the equipment's sens-
ing coil. This information can include the coffee name,
BREW VOLUMES, DILUTION PERCENTAGES, PULSE
BREW TIMES, PREINFUSION TIMES and DRIP-OUT
TIMES for that particular recipe NAME. These can all
be loaded in seconds.
Contact Bunn-O-Matic Corporation for the avail-
ability of RECIPE CARDS.
NOTE: Instructions to program the brewer and grinder
are printed on the RECIPE CARD, along with the coffee
name that is being programmed.
Procedure to program the coffee name:
1. Remove the funnel (if present) from the funnel
rails.
2. Position the RECIPE CARD vertically, so that the
top end of the chip is beneath the funnel sensing
coil.
3. After a short pause the display will read CARD CON-
TAINS RECIPE FOR then will change to (RECIPE
NAME) SHOW QUIT SAVE. All brewing parameters
for that coffee flavor are now transferred from the
CARD to the brewer.
4. To show (view) this information, press and release
SHOW. The display will scroll through all of the
brew settings for all batch sizes. The display will
then return to CARD CONTAINS RECIPE FOR
then will change to (RECIPE NAME) SHOW QUIT
SAVE.
5. If all brew settings are correct, press SAVE. The
display will read (RECIPE NAME) SETUP COM-
PLETE. All brew settings for that name are now
stored in the brewer's memory.
6. If the brewing information is not correct, or it is
desired to exit the setup before the settings are
loaded into the brewer's memory, press QUIT. The
display will read (RECIPE NAME) NOT SAVED. The
display will then return to the MAIN SCREEN.
POSITION CARD UNDER
SENSOR COIL
(RECIPE NAME)
SHOW QUIT SAVE
CARD CONTAINS
RECIPE FOR
READY TO BREW
WATER TEMP: 93º
(RECIPE NAME)
SETUP COMPLETE
(RECIPE NAME)
NOT SAVED
SCROLLS THROUGH ALL
OF THE BREW SETTINGS
FOR THE BATCH SIZES
FOR THAT RECIPE
P3210
37467 032808