Specifications

en
8
Rinse aid
As soon as the rinse-aid refill indicator
10
lights up on the control panel,
refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses.
Use only rinse aid for domestic dish-
washers.
Combined detergents with rinse-aid com-
ponent may be used up to a water hard-
ness of 21 _dH (37 _fH, 26 _Clarke,
3,7 mmol/l) only. If the water hardness
is over 21 _dH, rinse-aid must be used.
Open the dispenser
29
by pressing
and lifting the plate on the cover.
Carefully pour rinse aid up to the max.
mark in the filler opening.
Close cover until it clicks shut.
To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.
Setting amount of rinse-aid
The amount of rinse aid dispensed can
be set in 4 stages. Accordingly 0, 1, 2
or 3 displays are lit.
(see water hardness table).
Factory setting: 2.
Do not change the amount of rinse-aid
unless streaks (select lower setting)
or water stains (select higher setting)
are left on the utensils.
Open the door.
Switch on ON/OFF switch
1
.
Hold down button >
6
and press
Start button
9
until the End display
8 and salt refill indicator 11 flash.
Release buttons.
Keep pressing button >
6
until the
rinse aid refill indicator
10
flashes.
Release buttons.
The rinse-aid refill indicator
10
flashes
and the displays
A and B are lit (=
setting 2).
Change the setting as follows:
Press button <
5
until the required
setting has been selected.
Press Start button
9
.
The End display
8 and rinse aid refill
indicator
10
go out.
The selected setting is saved.
Close the door.
Switching off rinse-aid refill
indicator
If the rinse-aid refill indicator
10
is
impaired (e.g. when using combined
detergents containing rinse-aid
component), it can be switched off.
Proceed as described under
“Setting amount of rinse aid” and select
setting 0.
The rinse-aid refill indicator
10
is now
switched off.
Downloaded from DishWasher-Manual.com Manuals