Specifications

en
20
“check water supply”
12
display
lights up.
Tap turned off.
Water supply interrupted.
Supply hose kinked.
Filter in the water supply blocked.
Switch off the appliance and
pull out the mains plug.
Turn off the tap.
Clean filter in the supply hose.
Reconnect power supply.
Turn on the tap.
Switch on the appliance.
Water is left in the appliance
at the end of the programme.
Waste water hose is blocked
or kinked.
Waste water pump blocked,
cover on the waste water pump
is not locked in position
(see Maintenance and Care).
Filters blocked.
The programme has not yet
ended. Wait until programme
ends or implement ”Reset”
function.
The “Check water supply” display
12
flashes rapidly.
Water in the safety system.
Switch off the appliance and
pull out the mains plug.
Turn off the tap.
Contact customer service.
Refill indicator for salt
11
and/or
rinse-aid
10
is not lit.
Refill indicator/s switched off.
Adequate salt/rinse-aid available.
... during the wash cycle
Unusual foam formation
Handwash liquid in the rinse
aid dispenser.
Spilled rinse-aid causes excessive
frothing, therefore please remove
with a cloth.
Appliance stops during the wash
cycle.
Power supply interrupted.
Water supply interrupted.
Knocking/rattling noise during
rinsing
Spray arm is striking utensils.
Utensils not arranged correctly.
Filling valves making striking
noises
Caused by the installation of the
water line and has no effect on the
function of the machine. Remedial
action is not possible.
... on the utensils
Food residue on the utensils.
Utensils placed too closely
together, utensils basket overfilled.
Too little detergent.
Rinse programme too weak.
Spray arm rotation obstructed.
Spray arm nozzles blocked.
Filters blocked.
Filters incorrectly inserted.
Waste water pump blocked.
Top basket on right and left not set
to same height.
Tea or lipstick residue is not
completely removed.
Detergent has inadequate
bleaching effect.
Too low rinsing temperature.
Too little/unsuitable detergent
Downloaded from DishWasher-Manual.com Manuals