Specifications

Bunn-O-Matic Corporation
11
Uploading a Recipe Using a Recipe Card
The recipe card includes all the information needed to set up that particular tea/coffee name. The information from
the recipe card is loaded into the brewer’s memory by holding the chip area up to the brewer’s sensing coil. This
information can include all the recipe settings for that particular name. These can all be loaded in seconds.
Note: Instructions to program the brewer are printed on the recipe card, along with the tea or coffee name that is be-
ing programmed.
Procedure to program the coffee name:
Step 1: Remove the funnel.
Step 2: Position the recipe card vertically, so that the top end of the chip is beneath the sensing coil (located on the
under side of the front panel).
Step 3: After a short pause the display will read CARD CONTAINS RECIPE FOR then will change to (RECIPE
NAME)SHOW-QUIT-SAVE.AllbrewingparametersforthatrecipearenowtransferredfromtheCARDtothebrewer.
Step 4: To show (view) this information, press and release SHOW. The display will scroll through all of the brew set-
tings for that recipe. This display will then return to CARD CONTAINS RECIPE FOR then will change to (RECIPE
NAME)SHOW-QUIT-SAVE.
Step 5:Ifallbrewsettingsarecorrect,pressSAVE.Thedisplaywillread(RECIPENAME)SETUPCOMPLETE.All
brew settings for that name are now stored in the brewer’s memory.
Step 6: If the brewing information is not correct, or it is desired to exit the setup before the settings are loaded into
thebrewer’smemory,pressQUIT.Thedisplaywillread(RECIPENAME)NOTSAVED.Thedisplaywillthenreturnto
the main screen.
Note: The recipe is now saved in the brewer’s memory. To brew using this
recipe, it must be assigned to a brew button.
Calibrating the Sprayhead Flow Rate
Step 1: Place a measuring container with a minimum capacity of 60
ounces beneath the funnel of the brewer. Water can also be dispensed into
the server and then into the measuring container.
Step 2: Press and hold the right hidden switch to enter level 2 program-
ming. Continue
to press the right hidden switch until the display reads CALIBRATE FLOW
?.
Step 3: Press YES to advance to the SPRAY HEAD CAL? function screen.
Step 4: Press YES. The display will read CONTAINER READY? If the
container is under the funnel, press YES. The display will read CALIBRATE
SPRAY…PRESS BREW TO START.
Step 5: Press and release the BREW switch (on the side to be calibrated
for DUAL brewers). The display will read CALIBRATE SPRAY…60 SEC TO
FINISH. The 60 second timer on the display will count down to zero. When
the counter reaches zero, the display will change to OZ, along with the
existing ounces per minute.
Step 6: Measure the amount of water in the container and using the (-) or
(+), adjust the amount on the
display to match the amount in the container. Then press DONE.
Step 7: The display should now read: NEW SPRAY FLOW along with the
correctowrateofthesprayheadinouncesperminute.After5seconds,
the display will return to the CALIBRATE FLOW screen.
SPRAYHEAD CAL
NO YES
CALIBRATE FLOW?
NO YES
BREW
COUNTERS
CONTAINER READY ?
QUIT YES
CALIBRATE SPRA Y
PRESS BREW START
CALIBRATE SPRA Y
60 SEC TO FINISH
L/R OZ XX.X
(-) DONE (+)
NEW SPRAY FLOW
XX.X OZM
CALIBRATE FLOW?
NO YES
5 sec