Specifications

5
NUMBER NAME NUMBER NAME
1 Regular 15 Jamaica Blue Mtn
2 Decaf 16 Guatemalan
3 Colombian 17 Light Roast
4 Colombia Supremo 18 Dark Roast
5 Costa Rican 19 Espresso
6 Ethiopian 20 Amaretto
7 Kona 21 Hazelnut
8 Kenya AA 22 French Vanilla
9 Sumatran 23 Irish Creme
10 French Roast 24 Vanilla Nut
11 Italian Roast 25 Caramel
12 Mocha Java 26 Raspberry
13 House Blend 27 Almond
14 Breakfast Blend 28 Dark Mtn Roast
33736 052802
COFFEE CHART
COMMUNICATING WITH COFFEE BREWER
When the grinder is used with its companion brewer, the name of the coffee and the size of the batch ground
is communicated to the brewer through the chip in the funnel handle as it is placed into the brewer. Therefore, it
is necessary to “tell” the grinder the names of the coffees that have been loaded into the hoppers. The names are
chosen from the Coffee Chart shown below. Contact the factory if custom names that are not on the chart are
required.
SELECTING COFFEE NAMES
Entering a coffee name from the chart below:
1. Simultaneously press and hold the
button and any one of the three batch buttons on the side to be
programmed. After 3 seconds all three indicators on the side selected will begin flashing. The display will
show a number from the coffee chart below. This number represents the name of the coffee that is to be
loaded into the hopper.
2. Press and release to increase the number or press and release to decrease it.
3. When the correct number for the coffee being used is displayed, press any of the batch buttons on the other
side. All three indicators on that side will begin flashing.
4. Repeat step 2 to enter the name for the coffee being used on this side.
5. To exit the setup mode, press and release the ® button anytime during this procedure. The ® button is a
hidden programming pad located at the upper right corner of the BUNN
®
logo.
Entering a coffee name using a RECIPE CARD.
1. Press button and place the chip portion of the card under the sensor coil on the front of the grinder.
2. After a short pause, the display will show 3 “dashes”.
3. Remove the card and press any batch switch on the side to be programmed.
4. The display should show the number of the coffee name loaded into the grinder.
5. The grinder display will then return to the normal operating mode.
NOTE: If a number is chosen from the chart below, and entered into the grinder, check to be sure the number
entered represents the name of the coffee on the chart.
1. Grind into the funnel then insert the funnel into the brewer funnel rails.
2. The display will read the coffee name that was ground into the funnel.
3. If this name is different from the name on the chart, the grinder’s memory needs to be reset.
Resetting the grinder memory (to match the chart below)
1. Unplug grinder from the outlet.
2. Press in and hold both the and buttons and plug cordset into the outlet. After a short pause, the
display will show a series of 3 dashes followed by a series of 9 dashes.
3. When the 9 dashes appear, release the and buttons, then press and release the button.
4. The display will count down then return to the normal operating mode. The grinder should now be set to
match the coffee names with the numbers on the chart below.