FPG OPERATING & SERVICE MANUAL BUNN-O-MATIC CORPORATION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 FAX: (217) 529-6644 36783.0000A 05/04 ©2004 Bunn-O-Matic Corporation www.bunnomatic.
CONTENTS User Notices .............................................................3 Electrical Requirements ............................................3 Operating Controls....................................................3 Cleaning ....................................................................4 Coffee Grinding .........................................................4 Initial Set-Up .............................................................5 Adjustments .........................................
USER NOTICES Carefully read and follow all notices on the grinder and in this manual. They were written for your protection. All notices on the grinder are to be kept in good condition. Replace any unreadable or damaged labels. #05876.0000 #20545.
CLEANING EXTERIOR SURFACES The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all surfaces on Bunn-O-Matic equipment. Care should be taken not to scratch the hopper or windows with any abrasive material. Regular cleaning will keep your grinder looking new for years. GRIND CHAMBER 1. WARNING - Unplug grinder before removal of any panel or grind chamber housing parts. 2. Empty all beans from the hopper. 3.
INITIAL SET-UP/ADJUSTMENTS The grind can be set from fine to very coarse. The grind may be adjusted for use in most commercial coffee brewers. The following procedures should be used to make adjustments. NOTE - A change in the burr adjustment will also change the amount dispensed. Any adjustment to the burrs should be followed by an adjustment of the timer dials. SE - F INE AR Burr Adjustment CO 1. Unplug the grinder and empty all beans from the hopper(s). 2.
WIRING SCHEMATICS L1 SCHEMATIC WIRING DIAGRAM FPG B L K 2 W H I BLK 3 AMP SELECT SW.
L1 SCHEMATIC WIRING DIAGRAM FPGA B L K 2 R E D BLK 3 AMP SELECT SW.
