392 INSTALLATION & OPERATING MANUAL BUNN-O-MATIC CORPORATION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 FAX: (217) 529-6644 40305.0000A 07/07 ©2006 Bunn-O-Matic Corporation www.bunn.
INTRODUCTION This equipment will brew a half-gallon batch of coffee into an awaiting dispenser. It is only for indoor use on a sturdy counter or shelf. WARRANTY Bunn-O-Matic Corp. (“Bunn”) warrants the equipment manufactured by it to be commercially free from defects in material and workmanship existing at the time of manufacture and appearing within one year from the date of installation. In addition: 1.
USER NOTICES (cont.) ! WARNING Fill water tank before turning - on thermostat or connecting appliance to power source. Use only on a properly protected circuit capable of the rated load. Electrically ground the chassis. Follow national/local electrical codes. Do not use near combustibles. FAILURE TO COMPLY RISKS EQUIPMENT DAMAGE, FIRE, OR SHOCK HAZARD READ THE ENTIRE OPERATING MANUAL BEFORE BUYING OR USING THIS PRODUCT 39940.0000A 7/07 ©2007 BUNN-O-MATIC CORPORATION # 39933.0000 # 39940.0000 #39931.
ELECTRICAL REQUIREMENTS CAUTION - The brewer must be disconnected from the power source until specified in Initial Set-Up. All models have an attached cordset and plug. US models require 2-wire grounded service rated 120 volts ac, 15 amp, single phase, 60 Hz. "A" models require 2-wire, grounded service rated 220-240 volts ac, 10 amp, single phase, 50/60 Hz. "B" models require 2-wire, rated 100 volts ac, 15.0 amp, single phase, 50/60 Hz.
COFFEE BREWING 1. 2. 3. 4. 5. 6. Insert a BUNN® filter into the funnel. Pour the fresh coffee into the filter and level the bed of grounds by gently shaking. Slide the funnel into the funnel rails. Place an empty decanter beneath the funnel. Pour one pitcher of tap water into the screened area on top of the brewer. When brewing is completed, simply discard the grounds and filter. POUR IN WATER ONLY! CLEANING 1.
TROUBLESHOOTING A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems encountered. If the problem remains after exhausting the troubleshooting steps, contact the Bunn-O-Matic Technical Service Department. • • • Testing, and repair of electrical equipment should be performed only by qualified service personnel. All electronic components have 120 volt AC or low voltage DC potential on their terminals.
Page 7 WIRING DIAGRAM Wiring Harness, Ground # 37403.0000 Wiring Harness, Main # 37401.0000 Wiring Harness, Warmer # 37402.
18 15 11 16 14 10 17 13 7 12 6 1 5 8 19 9 20 21 22 2 4 23 24 3 25 Page 8
1 37355.0000 1 Funnel Assembly w/Decals 2 39766.0000 1 Pitcher 3 01188.0000 1 Deliming Spring 4 35286.0000 1 Thermostat 5 39772.0000 1 Sprayhead, 6 Hole 6 39775.0000 1 Nut, Hex .438"-20 7 37381.0000 1 Switch, DPST 8 37304.0000 37304.0001 37304.0002 37304.0003 1 1 1 1 Power Cord, 120V Power Cord, 230V CE Power Cord, 230V UK Power Cord, 100V 9 37322.0000 4 Foot, M6 x 1.0 Thread 10 37353.0000 1 Facade, Control Panel 11 37394.0000 37394.
