Specifications

Page 17
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
DRIP TIME
This function allows the operator to adjust the DRIP
TIME (time from end of sprayhead flow to when liquid
stops dripping from the funnel). When the brew cycle
is complete, the display will show DRIPPING and will
countdown the time until the funnel empties.
Setting DRIP TIME:
Range: OFF to 5 minutes for both batch sizes.
NOTE: If the brewer is already in the DRIP TIME screen,
skip steps 1 through 9 and proceed directly to step
10.
1. Press and hold the right hidden switch until the dis-
play reads SET LANGUAGE. Press the right hidden
switch until display reads BREW SETTINGS ?.
2. Press YES to proceed. The display should now
read:
MODIFY, SHOW and NEXT (SINGLE Brewers).
LEFT SIDE, along with MODIFY, SHOW and NEXT
(DUAL Brewers).
3. Press and release the right hidden switch until
display reads DRIP TIME: X:XX. A batch light will
be blinking.
4. Using the (-) and (+), set the amount of time from
when the brew solenoid shuts off to when drip-out
occurs for that batch size.
5. When finished, press the other batch size and repeat
step 4.
6. When finished, press DONE. The display should
read 2 BATCHES DONE?
7. If both batch sizes are not correct, press and release
NO to return to the DRIP TIME setup screen and
repeat steps 4, 5 and 6.
8. If both batch sizes are correct, press YES. The
display should read:
LEFT SIDE SETUP COMPLETE (DUAL Brewers).
SETUP COMPLETE (SINGLE Brewers).
After a 5 second delay, the display will advance to
REVIEW SETTINGS ?.
9. Press YES to scroll through all brew settings (left
brew settings for DUAL brewers). If all brew set-
tings are correct press NO. For SINGLE Brewers this
will advance display to XXX REFILL XXX. To exit to
the MAIN SCREEN, press and release the ON/OFF
switch. For DUAL Brewers the display should read
COPY SETTINGS ?
10. If NO is pressed, display will advance to RIGHT
SIDE, along with MODIFY SHOW NEXT; proceed
to step 13. If YES is pressed, display should read
LEFT->->->-> RIGHT
11. If NO is pressed, display will advance to RIGHT
SIDE, along with MODIFY SHOW NEXT; proceed
to step 13. If YES is pressed, display should read
ARE YOU SURE ?.
12. If NO is pressed, display will advance to RIGHT
SIDE, along with MODIFY SHOW NEXT. If YES is
pressed, display should read PLEASE WAIT, along
with COPYING L ->->->-> R. After a short delay
display will read RIGHT SIDE, along with MODIFY
SHOW NEXT.
13. If left settings were copied to the right side press
NEXT to advance display to XXX REFILL XXX.
If left brew settings were not copied to the right
side, press MODIFY and repeat the BREW SET-
TING procedure used to set the left side. To exit to
the MAIN SCREEN, press and release the ON/OFF
switch (either on DUAL bewers).
BREW SETTINGS (cont.)
41344 112508