Specifications

Page 12
L BREW OZ XXX.X
(-) DONE (+)
BREW SETTINGS
This function allows the operator to modify the BREW
VOLUMES, BYPASS PERCENTAGES and BREW
METER for each batch size of both brew stations.
Procedure to set or modify brew volumes.
Range: 10 to 500 oz.
1. Press and hold the right hidden switch until display
reads SET LANGUAGE. Press the right hidden switch
until display reads BREW SETTINGS ?.
2. Press YES to proceed. The display should now
read:
MODIFY, SHOW and NEXT (SINGLE Brewers).
LEFT SIDE, along with MODIFY, SHOW and NEXT
(DUAL Brewers).
3. Press and release MODIFY. The display should
read:
BREW OZ XXX.X: and a batch light will be blinking
(SINGLE Brewers).
L BREW OZ XXX.X: and a batch light will be blink-
ing (DUAL Brewers).
4. Using (-) and (+), set the amount of brew water, in
ounces, to be dispensed over the grounds for that
particular batch size.
5. When finished, press the other batch size and repeat
step 4.
6. When finished setting both batch sizes, press DONE.
The display should read 2 BATCH SIZES DONE?
7. If both batch sizes are not correct, press NO to
return to:
BREW OZ setup screen and repeat steps 4, 5 and
6 (SINGLE Brewers).
L BREW OZ setup screen and repeat steps 4, 5 and
6 (DUAL Brewers).
8. If both batch sizes are correct, press YES. This
will advance to the % BYPASS function. Another
alternative is to press and release the ON/OFF switch
(either for DUAL Brewers) to exit the BREW OZ
setup and return to the MAIN SCREEN.
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
LEFT SIDE
MODIFY SHOW NEXT
BREW SETTINGS ?
NO YES
BREW OZ XXX.X
(-) DONE (+)
% BYPASS XXX.X
(-) DONE (+)
MODIFY SHOW NEXT
PRESSING NO WILL
ADVANCE TO NEXT
FUNCTION SCREEN
2 BATCHES DONE ?
NO YES
SET BOTH
BATCH SIZES
SINGLE
BREWERS
DUAL
BREWERS
41344 112508