Specification Sheet

BUNN® reserves the right to change specifications and product design without notice. Such revisions do not entitle
the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
For most current specifications and other info visit bunn.com.
Last Updated:
02/03/2021
AXIOM®-DV-3 (2U/1L Warmer)
Server(s) sold separately
Adjusts automatically to varying water pressure
Automatic warmer shut-off
For high lime areas, BrewLOGIC® technology calculates flow rate and adjusts brew
time to maintain consistent pot levels
Electronic diagnostics and built-in tank drain make service easier
Ensure coffee quality with programming for brew level, cold brew lock- out and tank
temperature, set easily from the front of the machine
Coffee extraction controlled with programmable pre-infusion, pulse brew and digital
temperature control
Large 200oz. (5.9L) tank provides back-to-back brewing capacity
Energy-saver mode reduces tank temperature during idle periods
Hot water faucet
SplashGard® funnel deflects hot liquids away from the hand
Dual voltage adaptable (Can operate at 120V/15 amp or 120/208-240V/20 amp)
PROP 65 Warning Decal included in packaging with equipment
Servers not included unless otherwise noted
Agency:
Specifications Additional Features
38700.0008Product #: UpperFaucet: DBC
PlumbedWater Access:
Two Upper/ One Lower
Warmers:
Stainless
Finish:
Black PlasticFunnel:
WARNING: This product can expose you to chemicals including Bisphenol A (BPA), which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
Height: 18.9" Width: 8.4" Depth: 22.1"
(48.0cm) (21.3cm) (56.1cm)
Electrical & Capacity
Volts* Amps Watts
Cord
Attached
Plug Type
8oz cups/hr
236ml cups/hr
Input H²O
Temp.
Phase
# Wires
plus Ground
Hertz
120 15 1800 Yes NEMA 5-15P 67
60°F (15.5°C)
1 2 60
120/208
16 2980 -
N/A
121
60°F (15.5°C)
1 3 60
120/240
18 3850 -
N/A
121
60°F (15.5°C)
1 3 60
*When a BUNN is machine rated 120/208-240V, 120/208V or 120/240V, the higher voltage is the supply voltage needed to power the machine. The 120V is there to supply power to some components rated 120V in the machine, but it is not the supply voltage
and would not power the machine if the machine is marked with the before mentioned ratings.
Plumbing Requirements CAD Drawings
PSI kPa
Fitting Supplied
Water Flow Required (GPM)
20-90 138-621
1/4" Male Flare Fitting
-
2D
Revit
KLC
•