Installation & Operation Guide

4
ELECTRICAL REQUIREMENTS
The grinder has an attached cordset and requires 2-wire, grounded service rated 120 volts ac, 15 amp, single
phase, 60 Hz for 120V models; and 100 volts ac, 15 amp single phase, 50Hz for 100V models.
P1028
P1029
OPERATING CONTROLS
Off/On/Start Switch (Models LPG and LPG-2E)
OFF - (upper position) Switching to this position stops all operation of
the grinder.
ON - (middle position) The switch will return to this position after a grind
cycle has begun and will remain in this position after grinding has ceased.
START - (lower, momentary position) Pressing the switch to this position
and releasing initiates a grind cycle.
Hopper Selector Switch (Model LPG-2E only)
LEFT - Switching to this position allows beans to be ground from the left
hopper.
RIGHT - Switching to this position allows beans to be ground from the
right hopper.
27091 042211
WEEKLY CLEANING
Clean all exterior surfaces using a damp cloth rinsed in any mild, nonabrasive, liquid detergent. Care should
be taken not to scratch the grinder with any abrasive material.
6 MONTH CLEANING
1. WARNING - Unplug grinder before cleaning.
2. Empty all beans from both hopper(s).
3. Plug-in the grinder, place funnel with filter into funnel rails. Press the Off/On/Start switch to the “START”
lower position and release. Run a few grind cycles until all the coffee in the grind chamber is dispensed and
disconnect grinder from the power source.
4. Remove the funnel with filter and carefully tip the grinder over on it’s back.
5. Remove the two #10-32 screws securing burr housing cap assembly to the burr housing and remove the
burr housing cap assembly.
6. Remove load disc and slide rotator with lower burr, spring and brass bushing off to the motor shaft.
7. Clean the grind chamber and all parts with a dry non-metalic bristle brush and wipe with a dry clean cloth.
8. Reinstall brass bushing (flanged end first), spring and rotor with lower burr onto the motor shaft. Reinstall
load disc flat side toward rotar and burr housing cap assembly to the burr housing.
9. Refer to the initial setup/adjustments section to vary grind or weight of dispensed coffee if necessary.
Replace the dechaffer assembly.
20588.0000 Dechaffer Plate (2 required)