Spec Sheet

BUNN® reserves the right to change specifications and product design without notice. Such revisions do not entitle
the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
For most current specifications and other info visit bunn.com.
Created on:
10/14/2016
iMIX-5S+HOT&ICED
32.8" x 24.0" x 19.3"
(83.3cm x 61.0cm x 49.0cm)
Servers and airpots sold separately
3 dispense nozzles for hot drinks and 2 for iced cappuccino with
split hot/iced cappuccino lighted display
One 3gal (11.35L) and One 2gal (7.57L) hot water tank, with
individually controlled thermostats, adjustable from 50° to 200°F,
for optimum drink quality for hot and cold products
Alphanumeric display allows adjustments and service operational
testing from front of machine. Also communicates advertising
messages, machine status and technical support contact
information
Can be set as push and hold or single size portion control
Capacity: Five 8lb (3.6kg) hoppers
Cup clearance at 7.25” (18.4cm) to accommodate popular cup
sizes [adjustable to 8.12” (20.6cm)]
Easily removable side panels for complete access to service
components
Front of machine access to tank drain, dump valves, auger and
whipper motors and control board for easy service set up and
calibration
High speed heavy-duty whipper for complete product mixing
High efficiency LED lighted front graphics for merchandising
Spring-loaded, all metal auger drive system for easy hopper
installation
Variable speed motors allow control of product consistency in
mixing chamber (.75 to 6.6 grams of powder per second)
Agency:
Specifications Additional Features
40900.0000Product #: Side HingeDoor:
PlumbedWater Access: Portion Control
Dispense:
Black
Finish:
Push Button
Dispense:
FiveHoppers:
LitDoor:
Electrical & Capacity
Volts Amps Watts
Cord
Attached
Plug Type
8oz cups/hr
236ml cups/hr
Input H²O
Temp.
Phase
# Wires
plus Ground
Hertz
120 15 1800 Yes NEMA 5-15P 72
60°F (15.5°C)
1 2 60
Plumbing Requirements CAD Drawings
PSI kPa
Fitting Supplied
Water Flow Required (GPM)
20-100 138-689
1/4" Male Flare Fitting
-
2D
Revit
KLC

Summary of content (4 pages)