Spec Sheet

BUNN® reserves the right to change specifications and product design without notice. Such revisions do not entitle
the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
For most current specifications and other info visit bunn.com.
Created on:
10/14/2016
iMIX-3S OATMEAL
33.4" x 24.1" x 12.5"
(84.8cm x 61.2cm x 31.8cm)
Servers and airpots sold separately
4.3gal (16.3L) hot water tank to meet peak serving times
Adjustable drip tray
Front of machine access to tank drain, dump valves, auger motors
and control board for easy service, set up and calibration
Push and hold dispense
Hot water dispense button allows customers to adjust oatmeal
thickness to their preference
Key service components easily accessible through front, top and
easily removable side panels
Serves three instant oatmeals
High efficiency LED lighted front graphics for merchandising
Spring-loaded, all metal auger drive system for easy hopper
installation
Top-hinged design minimizes machine footprint
Agency:
Specifications Additional Features
38600.0054Product #: Top HingeDoor:
PlumbedWater Access: Push Button
Dispense:
Black
Finish:
ThreeHoppers:
LitDoor:
Electrical & Capacity
Volts Amps Watts
Cord
Attached
Plug Type
8oz cups/hr
236ml cups/hr
Input H²O
Temp.
Phase
# Wires
plus Ground
Hertz
120 15 1800 Yes NEMA 5-15P 72
60°F (15.5°C)
1 2
50/60
Plumbing Requirements CAD Drawings
PSI kPa
Fitting Supplied
Water Flow Required (GPM)
20-100 138-689
1/4" Male Flare Fitting
-
2D
Revit
KLC

Summary of content (4 pages)