Service and Repair Manual

12
SERVICE
This section provides procedures for testing
and replacing various major components used in this
dispenser should service become necessary. Refer
to Troubleshooting for assistance in determining the
cause of any problem.
WARNING - Inspection, testing, and repair of electrical
equipment should be performed only by qualified service
personnel. The dispenser should be unplugged when
servicing, except when electrical tests are required
and the test procedure specifically states to plug-in
the dispenser.
COMPONENT ACCESS
WARNING - Disconnect the dispenser from the power
source before the removal of any panel or the replace-
ment of any component.
All components are accessible by opening the door,
removal of the door panel, removal of the dispenser
rear panel, hopper, hopper support plate and top wrap-
around cover. Refer to Fig. 1
P1891
FIG. 1 COMPONENT LOCATIONS
41087.1 060112