Use and Care Manual
5
Bullyliner is a registered Trademark All rights reserved.
C.
APPLYING BULLY RUBBER COATING (Using a Paint Brush & Roller)
For best results, use:
1/4” nap micro fiber rollers &
regular house paint brushes
1. Use undiluted and apply onto the prepared surface. Two coats
is recommended for normal truck bed use. Apply unlimited,
additional coats for heavy duty use.
2. Putting down your first “tack” coat. A “tack” coat is a light coat
of material, gently brush/spray onto the surface to
establish good adhesion.
3. Allow the tack coat to dry to the touch before applying
additional coats. Depending on temperature and humidity,
allow (10 -15) mins in 15c° up
NOTE: Do Not apply material on too thick per coat or cracking will
occur. Allow each coat to dry to the touch before additional coats.
Do Not Apply below 10c° temperature
Stir the container to mix any
settling of material.
1/4” Nap micro roller
Regular house paint brush
WARNING: KEEP OUT OF REACH OF CHILDREN.