user manual
Monitor
Skip this step if installing on a 2006 vehicle. The OutLook Sub-Harness is not used during
installation on a 2006 vehicle.
:
1. Disconnect the stock information plug from the stock information plug receiver. The plug is located on the driver
side of the engine bay on top of the engine. To disconnect, gently press the lever ears in and pull back on the
lever. The plugs should disconnect smooth and easily.
2. Plug the OutLook information plug into the stock information plug receiver and plug the stock information plug
into the OutLook information plug receiver.
3. Run the green connector (female) on the end of the OutLook Sub-Harness over to the back corner of the engine
bay on the drivers side and let it sit while installing the other harnesses.