Owner's manual

10
RAPID FLOW INSTALLATION
Rapid Flow Exhaust # 82410
8. At this point it is time to install the Straight
Pipe (s). You will need to measure and cut
the Straight Pipe (s) for the nal t. Keep
in mind when you make your nal cut you
will need to leave an extra 3 inches of over-
lap when you cut the Straight Pipe.
Don’t cut the ared end.
9. Once the entire exhaust system is installed,
inspect the system to ensure that no part
of the exhaust is in direct contact with the
chassis or body; adjustments may be neces-
sary.
10. Return to each of the Clamps and
tighten with a 9/16” wrench. Do not
over tighten the Clamps.
Measure for Straight Pipe
Complete System Installed
3”
9/16”