Owner manual

10
RAPID FLOW INSTALLATION
Rapid Flow Exhaust # 82223
11. Snug up the Hangers to hold the
system in place but do not tighten
completely as the system may need to
be adjusted in future steps.
12. At this point it is time to install the Straight Pipe.
You will need to measure and cut the Straight Pipe
for the nal t. Keep in mind when you make your
nal cut you will need to leave an extra 3 inches of
overlap when you cut the Straight Pipe. Do not cut
the ared end.
13. Once the entire exhaust system is installed, inspect
the system to ensure that no part of the exhaust is in
direct contact with the chassis or body; adjustments
may be necessary.
14. Return to each of the Clamps and tighten with a 9/16”
wrench. Do not over tighten the Clamps.
Measure Straight Pipe
Muffler
Complete System Installed
3”
9/16”