User Manual

11
RFI COLD AIR INTAKE
6. Connect the silicone couplers to the Stage 2 RFI tube.
• Do not tighten the band clamps. Leave them loose so
you can adjust the couplers into the correct position
during installation.
7. Prepare the 16 mm silicon hoses.
• Insert a barb connector into each hose.
• Put the band clamps on. Leave them loose. (Hint: It is
easier to tighten the clamps later if the screws are facing
the same direction.)
Installing the RFI Intake
1. Snap the prepared RFI base/MAF tube assembly onto the
stock bolts in the engine bay.