Manual

5 6
RFI COLD AIR INTAKE RFI COLD AIR INTAKE
2. Remove the engine cover.
a. Pop the cover o the front grommets by pulling up on
the front of the cover.
a. Pull the cover straight out toward the front of the
engine.
b. Make sure the rubber grommets are still attached to
the bottom of the engine cover. (If not, pull them o the
bolts in the engine bay and put them back on the cover.)
3. Disconnect the stock sensor plugs.
a. Disconnect the mass airow (MAF) sensor plug.
b. Disconnect the manifold absolute pressure (MAP)
sensor plug.
Installation
Installation can be
separated into three
parts: Rmoving the Stock
Intake, Preparing the RFI
Intake and Installing the
RFI Intake. The complete
installation of the RFI Cold
Air Intake system should
take about 20 minutes. The
assembly diagram shows
how the parts of the intake t together in sequence.
Removing the Stock Intake
1. IMPORTANT: Before beginning
installation, disconnect your battery
at the negative terminal. Failure to
disconnect the battery could result
in personal injury and/or damage to
your vehicle.
OEM Intake Lid
Band Clamp (4)
Coolant Line Connector (6)
OEM Engine Cover (2)
MAP Sensor (3)
MAF Sensor (3)