Manual

1 2
RFI COLD AIR INTAKE RFI COLD AIR INTAKE
Parts Description
RFI Lid
The easy-to-remove lid replaces the stock lid and allows
for hassle-free lter
maintenance. When the
lid is installed, the latch
mounts should line up with
the latches on the base.
This will ensure that the lid
creates a good seal with the
enclosure base and that the
latches close securely.
RFI Base
The base of the enclosure is designed to bring in large
amounts of cool air from outside the engine bay and keep it
separate from the hot environment under the hood. It also
holds the air lter and directs the airow to the turbo unit.
There are two features to
notice about the enclosure
to ensure a smooth and
eective installation: (1) the
round hole where the RFI
MAF tube will snap into the
back of the base and (2) the
foam secured to the inlet
of the box, which seals the
RFI base to the side of the
truck.
Introduction
This manual provides step-by-step installation instructions for
the Bully Dog Rapid Flow Induction (RFI) Cold Air Intake for
2011-2012 6.0L GM pickups and SUVs. Installation requires a
few basic tools and takes about 20 minutes.
Table of Contents
Parts ..................................................................... 1-4
Installation ............................................................ 5-15
Maintenance ........................................................ 17-18
Parts Included
RFI Lid .................................................................. (53102-1)
RFI Base ............................................................... (53102-2)
RFI MAF Tube ...................................................... (53203-3)
Stage 2 RFI Tube ................................................. (53205-3)
Air Filter with Band Clamp ................................... (224800)
Silicone Hose ....................................................... (53252-4)
Silicone Coupler – Hump ..................................... (53252-5)
Silicone Coupler – Straight .................................. (53252-6)
4.5″ Worm Drive Band Clamp (4) ......................... (53252-7)
#6 Hose Clamp (2) ............................................... (4-28201)
T15 Security Torx® Bit ......................................... (53203-94)
3
⁄
8
″ Black Oxide Phillips Screw (2) .........................(54100-94)
3
⁄
4
″ Black Oxide Phillips Screw ..............................(53205-94)
Black Oxide Washer ............................................. (53205-95)
M6 Flanged Bolt ................................................... (53254-98)
Tools Needed
• Flat-head screwdriver
• Phillips screwdriver
• 10 mm socket
• Bit driver
• Ratchet
Optional (Recommended):
• 12″ ratchet extension