User guide

8
RFI COLD AIR INTAKE
Preparing the RFI Intake
1. Snap the RFI MAF Tube into the RFI Base.
2. Remove the MAF sensor from the stock intake tube.
(Use the T20 Torx® bit.)
3. Attach the MAF sensor to the RFI MAF Tube.
• Use the MAF Sensor Gasket.
• Use one nylon washer (slid beneath the MAF sensor)
and one black oxide Phillips screw on each side.
IMPORTANT: Do not overtighten the screws, as this could damage the MAF sensor.