INSTALLATION Manual Rapid Flow Induction Vehicle Application ‘94-’02 Dodge Cummins 5.
RAPID FLOW INDUCTION TROUBLESHOOTING: If you have questions during the installation of this product, please visit www.bullydog.com/Product_Updates.php. The latest version of these instructions can be found at the same location. Please review the Troubleshooting section on page before calling technical support to cover most common issues. Technical support is available by calling 866-bullydog (866-285-5936). TABLE OF CONTENTS Introduction......................................................................
RAPID FLOW INDUCTION Introduction Introduction: The following instruction set covers installation and maintenance of the Rapid Flow induction system for 1994-2002 Dodge Cummins 5.9L. Prefilter recommended Recommended with this kit but not included is a Bully Dog prefilter which can be purchased through a local Bully Dog dealer. A prefilter blocks large particles and insects from becoming lodged in the filter ribs. This keeps air flow at a maximum and makes cleaning much easier.
RAPID FLOW INDUCTION Removing the Stock intake 1. Using a screwdriver, loosen the band clamp that holds the intake tube onto the stock filter housing. Disconnect the intake tube from the intake housing. 2. Remove the lid of the stock intake housing by unsnapping the clips that hold the lid in place. Also remove the stock filter pannel. 3. Notice the three screws at the bottom of the stock, these three screws are what secure the intake box to the vehicle.
RAPID FLOW INDUCTION Installing the RFI 1. Notice the RFI heat sheild has three holes on the bottom. Install the rubber grommets/screws taken from the stock intake box onto the RFI heat sheild. 2. Set the RFI filter housing into the engine bay. Line up the threaded posts on the coming upward from the fender well to the screw holes on the intake sheild. Secure the intake sheild by tightening the screws installed on the RFI to the threaded posts. 3.
RAPID FLOW INDUCTION Filter maintenance: The intake system should be cleaned at least once every three months; in dusty climates the filter should be cleaned more often. Cleaning the intake is a two part process, the first part of the process involves the physical cleaning of the filter with soap and water and the second part involves oiling the filter. To properly clean the filter, a Bully Dog cleaning kit should be used. Cleaning kits are available at any Bully Dog dealer.
RAPID FLOW INDUCTION warranty & disclaimer REMEMBER, THIS IS A PERFORMANCE PRODUCT, USE AT YOUR OWN RISK. This product is not intended to be used to break the law. Do not use this product until you have carefully read the following agreement. This agreement sets forth the terms and conditions for the use of this product. The installation of this product indicates that the buyer has read and understands this agreement and accepts the terms and conditions.
Bully Dog Technologies, LLC is a team built on integrity that is dedicated to leading the vehicle performance industry with an uncompromising code of ethics demonstrated in the soundness of its employees, excellent customer service and superior products. UNLEASH THE POWER WITH BULLY DOG PERFORMANCE PRODUCTS Downloaders OutLook Monitor Custom OutLook Pod Exhaust Systems See More at: bullydog.com Doc.# BD50016 Version 1.0.0 For a full listing of Diagnostic Trouble Codes go to: www.bullydog.com/DTC.
