User guide

3
RAPID FLOW INDUCTION
rEmOvINg ThE STOCk INTAkE
1. Disconnect the coolant overll hose, this will make the
removal of the stock intake easier.
2. Disconnect the Mass Air Flow sensor:
• (‘03, ‘04, ‘06, ‘07) Using a bit driver
and the torques bit included unscrew
the torques screws that hold the mass
air ow sensor onto the air intake exit
tube. Once the screws are out pull the
mass air ow sensor out of the tube,
disconnect it from the harness holder
and move it aside while completing
the installation.
• 2005 The mass air ow sensor sits in a
grommet that holds it in place on the
intake exit tube. Remove the MAF sen-
sor by simply pulling up on the sensor,
then disconnect it from the harness
holder and move it aside while com-
pleting the installation. Also remove
the grommet that holds the MAF sen-
sor in place from the stock intake, that
grommet will need to be installed on
the RFI along with the MAF sensor.