Manual

10
Sensor Docking Station
F (IN): The F/IN port supports 5 volt and 5000 Hertz pulse
output sensors; it will appear as FREQUENCY in the Gauge
Setup menu on the GT or WatchDog. A two-wire speed
sensor (optical or magnetic) is the typical sensor type that
would be used with this port. NOTE: For the information from
frequency sensors to be displayed properly, further setup and
specications from the sensor manufacturer are required. See
page 29 for more information about the frequency sensor
wiring and setup with a GT or WatchDog.
+5V (OUT): This port supports a two-wire 0-5 volt temperature
sensor; it will appear as AUX Temp on the Gauge Setup menu
on the GT or WatchDog. Bully Dog recommends the GM
Delphi15326386uidtemperaturesensor;theSensorDocking
Station is calibrated for this sensor by default. Although other
brands of sensors are supported, they will require additional
calibration and are not recommended. See page 32 for more
information about wiring and setup.
OXYGEN: This port is only available on part #40385. The
Sensor Docking Station will only work with the Bosch LSU 4.9
wideband O
2
sensor (manufacturer part #17025). Calibration is
not required. Data from the O
2
sensor is displayed as A/F Ratio
1 (and 2) in the Gauge Setup menu and Air/Fuel Ratio 1 (and 2)
on the main screen of the GT or WatchDog. See pages
35-37 for information on installing and purchasing the O
2
sensor.
P1 P2 AN1 AN2 AN3 F
-
+++Y+
PWROXYGEN
R- Y+ R-
--
+5v