Instruction Manual

63
Introduction Parts Description PMT Installation Operating Instructions
APPENDIX:
The appendix contains important information for the PMT and is split into ve sections.
• SECTION 1: PYROMETER CALIBRATION PROCEDURE
• SECTION 2: TRANSMISSION RELEARN PROCEDURES: FORD AND GM
• SECTION 3: CUSTOM APILLAR PART NUMBER INFORMATION
• SECTION 4: TROUBLESHOOTING/ERROR CODES
• SECTION 5: FORMATTING SD CARD
• SECTION 6: WARRANTY/DISCLAIMER
SECTION 1:
PYROMETER CALIBRATION PROCEDURE
BEFORE THIS STEP CAN BE COMPLETED, COMPLETELY INSTALL THE PMT AND ALL OF ITS COMPONENTS.
1. Vehicle must be set to Stock HP/TQ levels-meaning no HP/TQ modications of any kind (downloader or plug-in
modules).
2. Engine must be put under full load for as long as possible on the hottest day possible. It is suggested to drive up a
hill or pull a trailer.
3. During a heavy load pull, record the highest reading.
4. Take that reading and add 150° to the high number and that will be your new defuel number that you do not
want to exceed.
APPENDIX
Internet Updates Appendix